Parameterizing
9.2 Parameterizing the operator interface
SENTRON PAC3100
94 Manual, 07/2009, A5E02385159B-01
PASSWORD Four-digit, numeric password.
Default value: 0000
(1) Password protection switched off
(2)
Password protection switched on
Figure 9-11 "PASSWORD PROTECTION" device setting
See also
Password management (Page 95)
RESET
The "RESET" dialog box enables resetting of the device settings to the instantaneous values
or the factory default values. The following groups of values can be reset:
● Maximum/minimum values
● Counters
● Factory defaults
● Communication parameters
F4
does not immediately reset a value group but marks the group instead. The
"EXECUTE..." menu entry resets the marked value groups.
NOTICE
Restart of the device
Resetting to the factory defaults results in restart of the device.
NOTICE
Access protection is switched off
Resetting to the factory defaults deactivates device protection. Password protection is
switched off. The password is set to the value "0000".
NOTICE
Counter - Reset
Resetting to the factory defaults has the effect of resetting all counters!
To Next Page
Loading...
