Siemens SENTRON PAC4220 - 3.5 Panel Mounting

3.1 Panel mounting
Tools
Y
ou require the following tools for installation:
• Cutting tool for the panel cutout
• PH2cal. screwdriverISO6789
• Cable grips for strain relief on all connecting cables
Mounting and clearance dimensions
You can 󹪝nd information on the cutout dimensions, frame dimensions and clearance
dimensions in the chapter Dimensional drawings (Page111).
Installation steps
Proceed as follows to install the PAC4220 in the control panel:
1. Open the packaging and carefully remove the device.
2. Read the enclosed operating instructions.
3. Carry out the following installation steps.
Figure3-1 Installation
Installation
3.1Panel mounting
PAC4220
Equipment Manual, L1V30827278B-01 41