Siemens SENTRON PAC4220 - 6.1.3 Measured Value Level

• Setting level
• Editing le
vel
0HDVXUHGYDOXH
OHYHO
0DLQPHQXOHYHO
Å6HWWLQJV´
6HWWLQJOHYHO(GLWLQJOHYHO
Depending on the device version and 󹪝rmw
are status, the availability of the measured values
may vary in the measured value and main menu levels. The parameter selection options at
the setting and editing levels also depend on the device version and 󹪝rmware status.
6.1.3 Measured value level
By default, the device is at the measured value level.
At the measured v
alue level, the available measured values can be read o󹪜. All possible
measured values are listed in the table in chapter Measured variables (Page23). The selection
of measured values depends on the device version and connection type.
• The
and keys can be used to scroll through the measured values.
• The key can be used to call additional information.
• The key can be used to switch the device to the main menu level.
Operation
6.1Device interface
PAC4220
Equipment Manual, L1V30827278B-01 67