Siemens SENTRON PAC4220 - 7.1 Parameterizing via Operator Interface; 7.1.1 Device Information

7.1 Parameterizing via the operator interface
You can par
ameterize the PAC4220 via the "Settings" menu option. You can 󹪝nd more
information on this in chapter Menu-based navigation (Page66).
The device settings are arranged into the following groups. The "SETTINGS" menu shows the
choice of groups:
• Device information
Article number and versions
• Language/Regional
Display language and designation of the phases on the display
• Basic parameters
Settings for the measuring inputs, averaging time of the sliding window demand, zero point
suppression, frequency
• Power demand
Settings for the load pro󹪝le
• Date/time
Time-related settings
• Integrated I/Os
Settings for using the digital inputs and outputs
• Communication
Network communication settings
• Display
Settings for the display
• Advanced
Password protection, limit values, universal counter, device reset, expansion modules
• Settings for expansion modules (only if an expansion module is used)
Functions for expansion modules available as options
7.1.1 Device information
The device information cannot be modi󹪝ed.
PAC4220 Device designation
7KM4220-1BA01-1EC0 Article number of the device
S/N: xxxxxx Serial number of the device
SW-REV: xxxx Firmware revision level
BL-REV: xxxx Bootloader revision level
LP-REV: xxxx Language pack version
Parameterizing
7.1Parameterizing via the operator interface
PAC4220
80 Equipment Manual, L1V30827278B-01