8 Operation at Use of a PC
8.3 Configuration of the Device
199SICAM Q100, 7KG95xx, Device Manual
E50417-H1040-C522-A4, Edition 03.2018
Parameterizing a Modbus Slave Device
If you want to change the settings of a Modbus slave device (for example, Modbus slave device 1), proceed as
follows:
✧ In the navigation window, click the Administrative menu and the menu item Modbus slave devices 1-4..
Figure 8-60 Configure tab, Modbus slave devices input/output window, device 1 activated
✧ Activate the device 1.
✧ In the Parameter fields, enter the desired values according to Table 8-24.
✧ In the Mapping columns, select the settings/activities which have been assigned to the buttons. The
function of the buttons is described in the chapters 8.3.7.4.2 to 8.3.7.4.5..
✧ After the parameterization click Send.
After clicking Send, the parameters are transmitted to the device but not enabled yet (passive set of
parameters).
✧ If you do not want to make any additional settings, continue with the Activation of the device configuration
according to section Activating the Set of Parameters. If you want to change other settings, enter the
changes and then enable the device configuration as described in section Activating the Set of
Parameters.
To Next Page
Loading...
