Siemens SIMATIC NET SCALANCE SC632-2C User Manual

Configuring with Web Based Management
4.4 "System" menu
SCALANCE SC-600 Web Based Management (WBM)
154 Configuration Manual, 10/2021, C79000-G8976-C475-03
• Security
Specify whether transfer of the e-mail from the device to the SMTP server is
encrypted. This is only possible when the SMTP server supports the selected setting.
Note
2
-factor authentication (2FA)
2
-factor authentication is not supported.
– SSL/TLS
– StartTLS
– None: The e-mail is transferred unencrypted.
• Test
Sends a test e-mail to the configured receivers.
• Test Result
Shows whether the e-mail was sent successfully or not. If sending was not
successful, the message contains possible causes.
Procedure
Configuring the SMTP server
1. Enable the "SMTP Client" function.
2. Enter the IP address or the FQDN of the SMTP server for "SMTP Server Address".
3. Click the "Create" button. A new entry is generated in the table.
4. Enter the name of the sender that will be included in the e-mail for "Sender Email
Address".
5. Enter the user name and password if the SMTP server prompts you to log in.
6. Under "Security", specify whether transfer to the SMTP server is encrypted.
7. Enable the SMTP server entry.
8. Click the "Set Values" button.
Note
Depending on the properties and configuration of the SMTP server, it may be
necessary to adapt the "Sender E
-Mail Address" input for the e-
mails. Check with the
administrator of the SMTP server.

Siemens SIMATIC NET SCALANCE SC632-2C Specifications

General

Brand	Siemens
Model	SIMATIC NET SCALANCE SC632-2C
Category	Switch
Language	English

Summary

Introduction

Security recommendations

Description

Function

Details the configuration and security functions of the device.

Technical basics

IP address

Explains the structure of IPv4 addresses, subnet masks, and CIDR notation.

Configuring with Web Based Management

Web Based Management

Describes the Web Based Management (WBM) interface and its requirements.

Starting and logging in

Provides steps for establishing a connection and logging into the WBM.

"System" menu

DHCP Server

Details the configuration of the device as a DHCP server.

Passwords

"Layer 2" menu

Configuration

Enables basic configuration for Layer 2 functions like MAC aging and redundancy.

"Layer 3" menu

NAT

Covers NAT general settings, masquerading, NAPT, source NAT, and NETMAP.

VRRPv3

Details VRRPv3 configuration for router redundancy and interface tracking.

"Security" menu

Users

Covers user account management, roles, and groups for security settings.

Passwords

Allows configuration and management of user passwords and password policies.

Firewall

IPsec VPN (SC64x-2C)

Details the configuration of IPsec VPN connections, phase 1 and phase 2 settings.

Upkeep and maintenance

Device configuration with PRESET-PLUG

Explains how to configure devices using the PRESET-PLUG.

Restoring the factory settings

Exchange of configuration data with STEP7

Exchange of configuration data with STEP 7 Basic/Professional using a file