Additional Commissioning and Configuration
Process Control System PCS 7 - PCS 7 BOX
5-4 A5E00272813-01
CW on the External ES
Requirement
• Installation of PCS 7 V6.0 SP3
Note
The Windows 2000 Professional Hardware Wizard may appear during the
commissioning of all the communication CPs.
Close this Wizard when any new hardware is detected.
Follow These Steps:
1. Use the CP 5611 module for your PCS 7 project by activating the option "Use
module in configured PC station for production".
2. Specify the slot in the "Index" field.
3. Use the Ethernet network card for your PCS 7 project by activating the option
"Use module in configured PC station for production" and specifying the slot in
the "Index" field.
Additional Information
Manual PC Configurations and Authorizations
To Next Page
Loading...
