– "Ready to complete" status display, when the SFC is not self-terminating (SELFCOMP
= 0) and is waiting in the run state for the "Complete" command (display, if READY_TC
= 1).
Note
To view "Continuous mode" and "Ready to complete", refer to the screenshot in the
section: "SFC chart" faceplate, "SFC section" view (Page 34).
– The status display of the sequencer after CPU startup
Startup with consistent data or
Startup with inconsistent data
– The display for an interconnection error (or empty box)
– The display for an operator error (or empty box)
– The display for a step error (or empty box)
– The display for an operator prompt (or empty box)
– The button for group acknowledgement
The buttons:
– For selecting "MANUAL" or "AUTO" mode
– For enabling changeover to "AUTO"
– Start (only active in the "Prepared values" view)
– Hold
– Resume
– Abort
– Complete
– Stop
– Restart
– Reset
The check boxes for enabling and disabling the execution options "command output",
"cyclic execution", and "time monitoring".
Operating and monitoring SFCs
6.5 "SFC Instance" faceplate, "Actual Values" view
SFC Visualization (V9.0)
Programming and Operating Manual, 05/2017, A5E41356392-AA 39
To Next Page
Loading...
