Siemens Simatic S7-1500 / ET 200MP - Introduction

Automation system
System Manual, 01/2023, A5E03461182-AK
9
Introduction
1
Purpose of the documentation
This documentation provides important information on configuring, installing, wiring and
commissioning the S7-1500 automation system/ET 200MP distributed I/O system.
Basic knowledge required
General knowledge in the field of automation engineering is required to understand this
documentation.
Validity of the documentation
This documentation applies to all products of the SIMATIC S7-1500 and SIMATIC ET 200MP
product families.
Conventions
STEP 7: In this documentation, "STEP 7" is used as a synonym for all versions of the
configuration and programming software "STEP 7 (TIA Portal)".
Please also observe notes marked as follows:
Note
A note contains important information on the product describe
d in the documentation, on
the handling of the product or on the section of the documentation to which particular
attention should be paid.