Siemens Simatic S7-1500 / ET 200MP - Creating the Control Data Record

Flexible automation concepts
11.2 Configuration control (option handling)
Automation system
System Manual, 01/2023, A5E03461182-AK
241
11.2.2 Creating the control data record
Required steps
To create a control data record for the configuration control, follow these steps:
1. Create a PLC data type that contains the structure of the control data record.
You can find the structure of the control data record:
– For the S7-1500 automation system in section Control data record for the S7-1500
Automation System (Page 244).
– For the ET 200MP distributed I/O system in section Control data record for the
ET 200MP distributed I/O system (Page 245).
Figure 11-3 Creating control data record 196 using an S7-1500 CPU as an example
2. Create a global data block.