Flexible automation concepts
11.2 Configuration control (option handling)
Automation system
240 System Manual, 01/2023, A5E03461182-AK
Required steps
Enable the "Allow to reconfigure the device via the user program" parameter when
configuring the CPU/interface module.
• For an S7-1500 CPU, you can find the "Allow to reconfigure the device via the user
program" parameter in the "Configuration control" area.
• For an IM 155-5 PN interface module, you can find the "Allow to reconfigure the device via
the user program" parameter in the "Configuration control" field under "General">"Module
parameters".
Figure 11-2 Enabling configuration control using an S7-1500 CPU as an example
To Next Page
Loading...
