Dimension drawings
A.8 Dimension drawings of the labeling strips
Automation system
362 System Manual, 01/2023, A5E03461182-AK
A.8 Dimension drawings of the labeling strips
Figure A-13 Dimension drawing of labeling strips for 35 mm modules
Figure A-14 Dimension drawing of labeling strips for 25 mm modules
A.9 Dimension drawing of test probe for measurement tap
To perform measurements on the front connector of the S7-1500/ET 200MP automation
system, you need a test probe with the following properties:
• Maximum diameter at measuring tip: 1 mm
• Length of measuring tip: ≥ 10 mm
Figure A-15 Dimension drawing of test probe for measurement tap
Corresponding test probes are available from electrical retailers.
To Next Page
Loading...
