Installation
6.3 Installing the standard rail adapter
Automation system
System Manual, 01/2023, A5E03461182-AK
135
Properties
● The DIN rail adapter makes it possible to mount the S7-1500/ET 200MP mounting rail on
standard 35 mm DIN rails.
● The DIN rail adapter allows for the use of prefabricated control cabinet and terminal box
systems.
● The total length of the S7-1500/ET 200 MP mounting rail can be used again completely as
before.
● To ensure optimal stability, the clearance between the two DIN rail adapters must be no
more than 250 mm or less.
Figure 6-6 Distance between two DIN rail adapters
Note that, depending on the mounting rail width, the mounting rail adapter can protrude up
to 4
mm on each side due to the drill holes.
You can find an overview of the protrusion dimensions for the various DIN rails in the table
below.
To Next Page
Loading...
