Installation
6.8 Installing I/O modules
Automation system
System Manual, 01/2023, A5E03461182-AK
147
3. Pivot the I/O module towards the back.
4. Tighten the I/O module (tightening torque 1.5 Nm).
Figure 6-13 Installing I/O module
Uninstalling I/O modules
The I/O module is wired.
Proceed as follows to dismantle an I/O module:
1. Turn off all feed supply voltages.
2. Open the front cover.
3. For communications modules: Loosen and remove the connector from the module.
4. At I/O modules: Pull the front connector out of the I/O module using the unlocking strap.
Swivel the front connector downward. Remove the front connector from the guide grooves.
5. Loosen the fixing screw of the I/O module.
6. Pivot the I/O module out of the mounting rail.
To Next Page
Loading...
