Siemens Simatic S7-1500 / ET 200MP - Page 180

Wiring
7.10 Front connector for the I/O modules
Automation system
System Manual, 01/2023, A5E03461182-AK
179
Details view
The shielding bracket, the power supply element, and the shielding clamp are included in the
scope of delivery for the analog and technology modules.
The following figure shows the details view of a front connector with shield connection
element:
①
Shield clamp
⑥
Power supply element
② Cable sheathing removed (approx. 20
mm)
⑦ Shielding bracket
③
Strain relief (cable tie)
⑧
Supply lines
④
Signal cables
①+⑦
Shield contact
⑤
Front connectors
Figure 7-11 Details view for front connectors with shield connection elements
Preparing front connectors for I/O modules with shield contact element
Watch video sequence (https://support.industry.siemens.com/cs/ww/en/view/67462859)
To prepare the front connector for wiring, follow these steps:
1. Remove the connection separator from the lower part of the connector (Figure 1).
2. Insert the power supply element (Figure 2).
3. Insert the shielding bracket from below into the guiding groove of the front connector until
the shielding bracket latches into place (Figure 3).