Maintenance
14.3 Replacement of I/O modules and front connectors
Automation system
System Manual, 01/2023, A5E03461182-AK
309
3. Additionally for F-modules:
– Carefully remove the electronic coding element from the front connector. Take care
not to damage the coding element.
– Insert the removed electronic coding element into the new front connector.
Figure 14-10 Removing the electronic coding element from the front connector and inserting it
into a new front connector
4. Insert the new front connector into the existing I/O module, until your hear it click into
place.
5. Wire the new front connector.
To Next Page
Loading...
