Siemens Simatic S7-1500 / ET 200MP - Page 347

Technical specifications
16.1 Standards, approvals and safety instructions
Automation system
346 System Manual, 01/2023, A5E03461182-AK
Industrial use
The S7-1500 automation system ET 200MP / distributed I/O system is designed for the
industrial field. It meets the following standards for this type of use:
• Requirements on interference emission EN 61000-6-4: 2007 + A1: 2011
• Requirements on immunity EN 61000-6-2: 2019
Use in mixed areas
Under certain conditions you can use the S7-1500 automation system ET 200MP / distributed
I/O system in a mixed area. A mixed area is used for residential purposes and for commercial
operations that do not significantly impact the residential purpose.
If you use the S7-1500 automation system / ET 200MP distributed I/O system in a mixed area,
you must comply with the radio frequency interference limits of the generic standard EN
61000-6-3. Suitable measures for observing these limits for use in a mixed area are, for
example:
• Installation of the S7-1500 automation system / ET 200MP I/O system in grounded control
cabinets
• Use of noise filters in the supply lines
An additional individual acceptance test is also required.
Use in residential areas
Note
S7
-1500 automation system / ET 200MP I/O system not intended for use in residential
areas
The S7
-1500 automation system ET 200MP / distributed I/O system is not intended for use in
residential areas
. If you use the S7-1500 automation system / ET 200MP distributed I/O
system in residential areas, this may have an impact on radio/TV reception.
Reference
The certificates for the identifiers and approvals can be found in Siemens Industry Online
Support on the Internet (https://www.siemens.com/automation/service&support).