Technical specifications
16.5 Mechanical and climatic ambient conditions
Automation system
System Manual, 01/2023, A5E03461182-AK
351
Climatic ambient conditions
The following table shows the permissible climatic ambient conditions for the S7-1500
automation system/ET 200MP distributed I/O system during operation.
Table 16- 8 Climatic ambient conditions
Horizontal and vertical
mounting
See product data sheets for
the respective module on
the Internet
(https://support.industry.sie
mens.com/cs/ww/en/ps/td)
The lower permissible ambient temperature was extended for
the S7-1500 automation system/ET 200MP distributed I/O sys-
tem to -30 °C. Differences may exist for specific modules and
depending on the mounting position and, if applicable, load.
You must check the lower permissible ambient temperature for
each module in the product data sheets.
The product data sheets with daily updated technical specifica-
tions can be found on the Internet
(https://support.industry.siemens.com/cs/ww/en/ps/td) at Indus-
try Online Support. Enter the article number or the short de-
scription of the desired module on the website.
To increase the service life of the display, the display switches
off when the permitted operating temperature is exceeded. At
certain temperatures, the display switches off an on again. You
can find more information in the technical specifications in the
Corresponds to an altitude of -1000 m to 2000 m.
See the following section "Using the S7-1500 automation sys-
tem/ET 200MP distributed I/O system over 2000 m above sea
ANSI/ISA-71.04 severity
level G1; G2; G3
Using the S7-1500 automation system/ET 200MP distributed I/O system over 2000 m above sea
level.
Table 16- 9 S7-1500 (F) CPUs for maximum installation altitude 5000 m or 3000 m
Max. installation
altitude
To Next Page
Loading...
