Function
IP244
C79000–B8576–C861–02
5–22
Assignment in message 15 of data block DB-B
DW 30
DW 29
KM
KM
DW 25
DW 26
DW 27
Main control byte 4 (Message number) *)
Main control byte 4d Main control byte 1
Main control byte 2 Main control byte 3
Main control byte 7 Main control byte 6
DW 31
KY
DW 17
DW 16
DW 18
DW 20
DW 19
DW 21
DW 22
DW 23
DW 24
DW 28
KF
KF
KF
KY
KY
KF
KF
KM
KM
KM
KM
Recommended
data format
Acquisition time (RC) Approach time **)
Approach manipulated
variable **)
Approach setpoint
Max. temperature difference -
*) The message number must be entered by the user
**) Only for hot channel control
(RC) Required for read curve value function channel 13
(RA) Required for read curve value function channel 13
The main control bytes 1, 2, 3 and 6 are written to by the user.
The entries in the main control bytes 4, 4a to 4d, 5 and 7 are made by the function block;
these bytes should not be written to by the user. The very first entry in the main control byte
must be KM 0000 0000.
KY
Monitoring time for emergency programs
Normalization factor for channel 14 (RA)
Switchover value for the comparator (channel 13)
Normalization factor for channel 13 (RC)
- Coolant temperature
-
Approach zone **)
Main control byte 4b Main control byte 4c
Main control byte 5 Main control byte 4a
1)
1) The comparator function does not exist in the 6ES5244Ć3AB31 temerpatrue controller module. The parameter in DW 16
does not have an effect.
To Next Page
Loading...
