Description of system components
8.3 Operator panel with display
SIMOCODE pro
System Manual, 05/2019, A5E40507475002A/RS-AD/004
121
PROFINET:
Not only information about IP configuration, device name, MAC address, PROFIsafe address
but also settings about the status of communication and the response of SIMOCODE pro if
communication failures are displayed.
These are the most important menus by way of example:
● IP configuration
● Device name
● MAC address
● PROFIsafe address: Shows the PROFIsafe address
(only when DM-F PROFIsafe is installed)
● Baud rate
● Bus OK, bus monitoring
● PLC/PCS in Run, PLC/PCS monitoring
● Bus/PLC fault - reset
● Startup parameter block
● Diagnostics device error, diagnostics message: Shows which type of diagnostic
information is sent by SIMOCODE pro to a higher-level automation system via
PROFINET.
● Diagnostics warning, diagnostics trip: Shows which type of diagnostic information is sent
by SIMOCODE pro to a higher-level automation system via PROFINET.
To Next Page
Loading...
