Siemens SIMOCODE pro C - Exchanging a 3 UF52 Operator Panel for a 3 UF720 Operator Panel

Commissioning, service, troubleshooting
13.3 Service
SIMOCODE pro
System Manual, 05/2019, A5E40507475002A/RS-AD/004
283
The following table shows which 2nd generation current/voltage measuring module replaces
a 1st generation current/voltage measuring module:
1st generation current/voltage measuring module
2nd generation current/voltage measuring module
3UF7110-1AA00-0, I
e
= 0.3 to 3 A
→
3UF7110-1AA01-0, I
e
= 0.3 to 4 A
3UF7111-1AA00-0, I
e
= 2.4 to 3 A
3UF7111-1AA00-0, I
e
= 3.0 to 25 A
→
→
3UF7110-1AA01-0, I
e
= 0.3 to 4 A
3UF7111-1AA01-0, I
e
= 3 to 40 A
3UF7112-1AA00-0, I
e
= 10 to 100 A
→
3UF7112-1AA01-0, I
e
= 10 to 115 A
3UF7113-1AA01-0, I
e
= 20 ... 200 A
→
3UF7113-1AA00-0, I
e
= 20 ... 200 A
3UF7113-1BA01-0, I
e
= 20 ... 200 A
→
3UF7113-1BA00-0, I
e
= 20 ... 200 A
3UF7114-1BA01-0, I
e
= 20 ... 200 A
→
3UF7114-1BA00-0, I
e
= 20 ... 200 A
13.3.4 Exchanging a 3UF52 operator panel for a 3UF720 operator panel
To exchange a 3UF52 operator panel for the smaller 3UF720 operator panel, proceed as
follows:
Table 13- 23 Exchanging a 3UF52 operator panel for a 3UF720 operator panel
Step
Description
1 Unscrew the four mounting bracket screws and remove the 3UF52 operator panel from the front panel or
switchgear cabinet door.
2 Ensure that the dimensions of the cutout in the front panel or cabinet door measure 91.5 + 0.5 mm (width)
and 54.5 + 0.5 mm (height) (see figure).
3
Slide the seal provided onto the operator panel adapter (see figure).
4
Position the operator panel adapter in the cutout.
5
Position the operator panel in the adapter.
6
Snap the four mounting brackets onto the operator panel.
7 Lock the operator panel in position by tightening the four mounting bracket screws
(see figure and safety information!).