Siemens SIMOCODE pro C - Technical Data of the DM-F Local Digital Module

Technical data
15.6 Technical data of the expansion modules
SIMOCODE pro
System Manual, 05/2019, A5E40507475002A/RS-AD/004
349
15.6.3 Technical data of the DM-F Local digital module
Technical data of the DM-F Local digital module
LEDs on DM-F LOCAL
Color
Meaning
"READY"
OFF
System interface not connected / supply voltage too low / device defective
Green
Device ON/system interface OK
Flashing green
Device ON / system interface not active or not OK
"DEVICE"
OFF
Supply voltage too low
Green
Device ON
Flashing green
Self-test
Yellow
Configuration mode
Flashing yellow
Configuration error
Red
Device defective or faulty
"OUT"
OFF
Safety-related output not active
Green
Safety-related output active
Flashing green
Feedback circuit not closed although start condition satisfied
"IN"
OFF
Input not active
Green
Input active
Flashing green
Fault detected (e.g., cross circuit at input, sensor simultaneity not fulfilled)
"GF"
OFF
No general fault
Red
Group fault (wiring error, cross-circuit, configuration error)
Flashing red
Group fault (feedback circuit fault, simultaneity condition not satisfied)
"1"
OFF
Cross-circuit detection Off
Yellow
Cross-circuit detection On
Flashing yellow
Configuration mode waiting for confirmation
Flickering yellow
Configuration error
"2"
OFF
NC contact/NO contact
Yellow NC contact/NC contact
Flashing yellow Configuration mode waiting for confirmation
Flickering yellow
Configuration error
"3"
OFF
2 x 1-channel
Yellow
1 x 2-channel
Flashing yellow
Configuration mode waiting for confirmation
Flickering yellow
Configuration error
"4"
OFF
Debounce time Y12, Y22, Y34 ~ 50 ms
Yellow
Debounce time Y12, Y22, Y34 ~ 10 ms
Flashing yellow
Configuration mode waiting for confirmation
Flickering yellow
Configuration error
"5"
OFF
Sensor circuit, automatic start
Yellow
Sensor circuit, monitored start
Flashing yellow
Configuration mode waiting for confirmation