Mounting, wiring, connecting, system interfaces, configuration guidelines
12.1 Mounting
SIMOCODE pro
System Manual, 05/2019, A5E40507475002A/RS-AD/004
193
12.1.6 Mounting of the operator panel and operator panel with display
The operator panels are designed for installation in the front panels of motor control centers,
for example, or in control cabinet doors.
To install, proceed as follows:
Table 12- 2 Sequence for installing the operator panel / operator panel with display
1 Make a cutout, e.g. in the front panel or switchgear cabinet door. Dimensions (see figure
"Mounting the operator panel" or figure "Mounting the operator panel with display").
2 Position the operator panel or the operator panel with display in the cutout.
Snap the four mounting brackets onto the operator panel.
4 Lock the operator panel in position by tightening the four screws on the securing brackets.
Figure 12-8 Mounting the operator panel
To Next Page
Loading...
