Siemens SIMOCODE pro C - 5.8 Operating, service and diagnostics data

Overview of functions
5.8 Operating, service and diagnostics data
SIMOCODE pro
System Manual, 05/2019, A5E40507475002A/RS-AD/004
59
5.8 Operating, service and diagnostics data
SIMOCODE pro supplies a large amount of detailed operating, service and diagnostics data.
Operating data
● Motor switching state (ON, OFF, LEFT, RIGHT, SLOW, FAST), derived from the current
flow in the main circuit: thus, feedback via auxiliary contacts of circuit breakers and
contactors is not necessary.
● Current in phases 1, 2 and 3 and maximum current in % of current setting
● Voltage in phases 1, 2 and 3 in V
1)
● Frequency
7)
● Active power in W
1)
● Apparent power in VA
1)
● Power factor in %
1)
● Phase unbalance in %
● Phase sequence
1)
● Ground-fault current
6)
● Temperature in the respective sensor measuring circuits, and maximum temperature in
K
3)
● Current analog signal values
4)
● Time to trip in s
● Temperature rise for motor model in %
● Remaining cooling down period of the motor in s, etc.
It is possible to adapt the units via the device-internal conversion of individual measured
values with the help of the logic modules (calculators) provided by SIMOCODE pro. For
example, the temperature recorded by SIMOCODE pro can be calculated in either °F or °C
and transmitted to the automation system via PROFIBUS DP.