Glossary
SIMOCODE pro
394 System Manual, 05/2019, A5E40507475002A/RS-AD/004
SIMOCODE pro S7 slave
The SIMOCODE pro S7 slave is a special slave with the following characteristics:
● It supports the S7 model (diagnostic interrupts, process interrupts)
● It can be parameterized
SIMOCODE pro object manager (OM)
Part of SIMOCODE ES. When SIMOCODE ES and SIMOCODE pro object manager are
installed on a PC/PG, SIMOCODE ES can be called directly from STEP 7 HW Config. This
enables simple and universal SIMATIC S7 configuration.
SIMOCODE pro PCS-7 library
The SIMOCODE pro PCS 7 library is used to connect SIMOCODE pro to the
SIMATIC PCS 7 process control system. It contains:
● The diagnostics and driver modules corresponding to the diagnostics and driver concept
of SIMATIC PCS 7
● The elements (symbols and faceplates) necessary for operating and monitoring.
Service packs and hot fixes:
The PCS 7 libraries are subject to continual updating and improvement. You can download
the current service packs and hot fixes in the Industry Online Support.
Simple Network Management Protocol (SNMP)
Network protocol for monitoring and controlling network elements (e.g. switches).
Slave
PROFIBUS DP is based on a master-slave architecture. Telegrams are sent by the master
to the addressed station (slave) and responded to by the slave.
Stalled rotor protection
If the motor current rises above an adjustable stalled rotor protection level (current
threshold), a defined and delayable response can be configured for SIMOCODE pro. In this
case, for example, the motor can be shut down independently of the overload protection.
The stalled rotor protection is only active after the parameterized class time has elapsed,
e.g. for Class 10 after 10 seconds, and prevents unnecessarily high thermal and mechanical
loads as well as premature aging of the motor.
Standard function
Standard functions are typical motor functions that can be activated according to need and,
as applicable, individually set for each motor feeder. They are already available, work
independently of the selected control function and can be used/activated as optional
additions.
To Next Page
Loading...
Need help?
General
