• The half secondary section track is mounted.
• The slide stands above the range that has no secondary section.
Figure5-9 Initial situation when mounting the continuous cover band
1. Remove the clamping wedges of the secondary section end pieces and prepare an insertion
aid for the cover band.
Material that cannot be magnetized must be used and the width should approximately
correspond to that of the secondary sections (e.g. a wooden board as shown in the diagram
above).
2. Position the insertion aid at the end of the secondary section track so that a ramp is created.
3. Unroll the cover band and place it down on the insertion aid.
Installation
5.3Procedure when installing the motor
Naturally-Cooled 1FN3 Linear Motors
Operating Instructions, 06/2023, A5E52220465B AB 75
To Next Page
Loading...
