12.When coming into contact with the secondary section edge for the rst time, align the cover
band centered with respect to the secondary section and check that the band is correctly
positioned in the secondary section end piece. When placing down on the secondary
sections, continuously check the alignment at right angles to the traversing direction. If the
cover band signicantly deviates from the secondary section track, then it must be lifted and
realigned.
Figure5-13 Aligning the cover band
Installation
5.3Procedure when installing the motor
Naturally-Cooled 1FN3 Linear Motors
78 Operating Instructions, 06/2023, A5E52220465B AB
To Next Page
Loading...
