Siemens SIMOTICS L-1FN3 - Page 81

13.Place the cover band on the second end piece and check the position in the traversing
direction.
The cover band must be aligned in the traversing direction if the threaded holes for mounting
the clamping wedge are covered. In this case, it must be completely lifted o󹪜, so that a
marking on the cover band at the end of the already mounted parts of the secondary section
track (slide side) can be helpful when repositioning.
Figure5-14 Placing the cover band on the second end piece
14.Press in the clamping wedge once you have aligned the cover band.
15.Screw-in the 󹪝xing screws and tighten them.
Figure5-15 Screwing-in the 󹪝xing screws
Installation
5.3Procedure when installing the motor
Naturally-Cooled 1FN3 Linear Motors
Operating Instructions, 06/2023, A5E52220465B AB 79