16.Check again that the other end of the cover band is correctly aligned and the threaded holes
in the secondary section end piece are not covered, even when the cover band is slightly
pulled.
17.Push the slide over the mounted secondary section track to the other end position.
18.Release the cover band at the end without secondary section from the end piece and bend
it upwards without kinking it.
19.Fix the cover band and insert a wedge between the secondary sections and cover band to
compensate for the force of attraction.
Figure5-16 Fixing the cover band
20.Mount the remaining secondary sections.
Installation
5.3Procedure when installing the motor
Naturally-Cooled 1FN3 Linear Motors
80 Operating Instructions, 06/2023, A5E52220465B AB
To Next Page
Loading...
