5. Fasten the ends of the rst and last segments to the secondary section end pieces.
6. Place the primary section with spacer and forcing assembly on the secondary section track.
7. Mount the slide onto the guide.
8. Align the slide over the mounting holes of the primary section.
9. Remove the primary section from the secondary section track using the forcing assembly.
10.Mount the primary section securely on the slide.
❒
Note
Arranging segments of the cover
If you arrange the butt joints of the cover segments so that they are oset from the butt joints
of the secondary sections, the secondary section track will be better protected against dust. The
segments of the cover also align better.
This oset is achieved when the cover segments at the ends of the secondary section track
have a (n+0.5) length instead of the integral length of the secondary sections, see the
following diagram showing this.
6HJPHQWZLWKOHQJWK[/
6HJPHQWZLWKOHQJWK[/6HJPHQWZLWKOHQJWK[/
6HFRQGDU\VHFWLRQRIOHQJWK/
6HJPHQWRIWKHVHJPHQWHGFRYHU
VHFRQGDU\VHFWLRQWUDFN
/
Figure5-21 Example: Segment position of the segmented secondary section cover
Removing the segmented cover
If you want to remove the segmented secondary section cover, you must raise the segments
on one side transversely to the traversing direction as per the following gure.
Installation
5.3Procedure when installing the motor
Naturally-Cooled 1FN3 Linear Motors
Operating Instructions, 06/2023, A5E52220465B AB 83