Siemens SIMOTICS L-1FN3 - Power connection

To connect an absolute value encoder EnDat with 1V
PP
, order designation EnDat01 or
EnDat02, or SSI with 1V
PP
, you require the SME125.
To connect an incremental encoder (sin/cos 1V
PP
), you require the SME120.
/BUVSBMMZDPPMFE'/
XJUI5FNQ4
4*/".*$44
.PUPS.PEVMF
5ZQFPG
DPOTUSVDUJPO
#PPLTJ[F
"CTPMVUFFODPEFS
&O%BUPSJODSFNFOUBMFODPEFS
5FSNJOBMTUSJQ
4PMECZUIFNFUFSYNN


TDSFXUFSNJOBMT
TQSJOHMPBEFEUFSNJOBMT
$POOFDUPSTVCTFRVFOUMZ
NPVOUFE
$POUSPMDBCJOFU.BDIJOF
$POOFDUPS
PS
'94-
9
6781&
9
%29
9
'9ୢ%$%3*7&$-J2
4.&Y
4-""ୢ"
'9##
4-.""$
4-.#"$
Figure6-1 System integration with SME12x and separate cables for the signal and power connection (example)
The subsequent diagrams show 2 examples of motors integrated into systems where the
Temp‑S is connected via a TM120. A DRIVE-CLiQ encoder is connected directly to the TM120.
Electrical connection
6.3System integration
Naturally-Cooled 1FN3 Linear Motors
90 Operating Instructions, 06/2023, A5E52220465B AB