Siemens SIMOTION D4 Series - Page 46

Interfaces
3.4 PROFINET IO interface
SIMOTION D4x5-2
46 Manual, 11/2010
Interface position
The following figure contains information on the PROFINET interface of the control unit.
Position of the interface, labeling of the ports and the associated displays are described.
'LVSOD\
6WDWXV
*UHHQ
2II
<HOORZ
2II
0HDQLQJ
7UDQVIHUUDWHRU0ELWV
1RRUIDXOW\FRQQHFWLRQ
/$1FRQQHFWLRQ
1R/$1FRQQHFWLRQ
'LVSOD\ 'LVSOD\
6WDWXVRIWKHLQWHUIDFH31
6\QFKURQL]DWLRQVWDWXVRIWKHLQWHUIDFH6<
/('GLVSOD\VIRUWKHVWDWXVRILQWHUIDFH;
/,1.
$&7
;3
$&7
/,1.
;3
;3
Figure 3-3 Position of the PROFINET interface X150 P1 to P3 their displays
Note
The 3rd port of the PROFINET IO interface X150 P3 is also designated as X120 PN/IE OP.
This designation is not relevant for SIMOTION D.
Additional references
Detailed information on the states of the status LEDs can be found in the SIMOTION D4x5-2
Commissioning and Hardware Installation Manual, Diagnostics chapter.