Siemens SIMOTION D410-2 DP User Manual

Requirement
Symbolic
assignment is supported by the TO axis, TO externalEncoder and the TO outputCam,
TO camTrack and TO measuringInput. The onboard I/Os of a SIMOTION D, of a
SINAMICS S110/S120 Control Unit, and selected Terminal Modules can be interconnected
symbolically.
Module Supports symbolic assignment
SIMOTION D
●
SIMOTION D410-2
● SIMOTION D410
● SIMOTION D4x5-2
● SIMOTION D4x5
● As of SIMOTION V4.3
● As of SIMOTION V4.2
● As of SIMOTION V4.2
● As of SIMOTION V4.2
Controller extension
●
CX32-2
● CX32
As of SIMOTION V4.2
SINAMICS S110 CU305 As of SINAMICS V4.3
SINAMICS S120
●
CU310-2
● CU310
● CU320-2
● CU320
● As of SINAMICS V4.4
● As of SINAMICS V2.6.2
● As of SINAMICS V4.3
● As of SINAMICS V2.6.2
See also
Only the drive configuration by means of symbolic assignment is described in this
documentation.
You will find the documentation of older SIMOTION versions on the Internet at the following
address (http://support.automation.siemens.com/WW/view/en/40211807).
For further information on the configuration of the TO axis and TO externalEncoder, see the
TO Axis Electrical/Hydraulic, External Encoder Function Manual.
Commissioning (software)
7.1 Overview of commissioning
SIMOTION D410-2
142 Commissioning and Hardware Installation Manual, 01/2015

Siemens SIMOTION D410-2 DP Specifications

General

Brand	Siemens
Model	SIMOTION D410-2 DP
Category	Controller
Language	English