To Next Page

To Previous Page

Component Function

Motors with

DRIVE-CLiQ interface

… allow simplified commissioning and diagnostics, as the motor and encoder type are iden‐

tified automatically.

DMC20/DME20

DRIVE-CLiQ hub

… enables the number of DRIVE-CLiQ interfaces to be increased and the creation of a point-

to-point topology.

Note

Please note that SIMOTION D410‑2 components in booksize format (Controller Extension,

Motor Modules, Line Modules, etc.) are not supported.

SIMOTION D410‑2 can only be used with the following Power Modules:

● PM340

● PM240-2 as of SIMOTION V4.4/SINAMICS V4.7

Other Power Modules are not supported by SINAMICS G120 (e.g. PM230).

Note

You will find detailed information on components in the SINAMICS S110/S120 family of

products in the SINAMICS S110/S120 manuals.

It is possible that older DRIVE‑CLiQ components can no longer be used with SIMOTION

D410‑2. You will find detailed information on this in the SIMOTION D410‑2 Commissioning

and Hardware Installation Manual in Section "Migration of SIMOTION D410 to

SIMOTION D410‑2" under "Permissible combinations".

Siemens SIMOTION D410-2 DP User Manual

Questions and Answers: