Siemens SIMOTION Series User Manual

Parameter assignment/addressing
9
9.1 Parameter assignment / addressing requirements
The following actions should be completed before you start parameterizing or addressing:
● The SIMOTION P320‑4 and the other hardware are installed.
● The devices are connected.
● The required software is installed.
● The SIMOTION P320‑4 has been switched on.
The actual state should be saved after the parameterization.
9.2 Factory settings
9.2.1 Factory settings overview
Requirement
You have obtained information about the various communications models. Further information
can be found under HMI and SIMOTION SCOUT (Page 59).
You are familiar with the Windows Control Panel.
Resetting the factory settings
It is possible to reset SIMOTION P320‑4 to the factory settings (see section Resetting the
SIMOTION P to the initial state (Page 183)).
9.2.2 Ethernet - TCP/IP local
SIMOTION P320‑4 delivery state
Local communication in the SIMOTION P320‑4 between Windows programs such as HMI and
the SIMOTION P Runtime software is handled via the preset TCP/IP Ethernet communication.
As an alternative to TCP/IP, the PC internal (local) communication can also be used. Further
information on how to check the settings in the Windows Control Panel can be found in Section
Check PC internal settings (Page 137).
SIMOTION P320-4 E / P320-4 S
Commissioning and Hardware Installation Manual, 11/2016 127

Siemens SIMOTION Series Specifications

General

Interfaces	PROFIBUS, PROFINET, Ethernet, USB
Programming Languages	LAD, FBD
Safety	Integrated safety functions
Typical Applications	Machine automation, robotics, packaging, printing
Relative Humidity	5% to 95% (non-condensing)
Protection Class	IP20
Certifications	CE, UL, cUL