Siemens SINAMICS G120 - Default Setting of the Interfaces

4.5.6 Default setting of the interfaces
Default setting 7: "Fieldbus with data set switchover"
Factory setting for inverters with PROFIBUS or PROFINET interface
6SHHGDFWXDOYDOXH
&XUUHQWDFWXDOYDOXH
$ODUP
$FNQRZOHGJHIDXOW
-RJ
-RJRUVSHHG
VHWSRLQW
-RJ
6ZLWFKRYHUFRQWURODQG
VHWSRLQW
7HOHJUDP
-RJJLQJ
)LHOGEXVLVQRWDFWLYH
&RQWUROYLD352),GULYHWHOHJUDP
1RIXQFWLRQ
1RIXQFWLRQ
)DXOW
6SHHGVHWSRLQW
7HOHJUDP3='
', 
', 
', 
', 
', 
', 
', 
', 
', 
', 
 $2
 $2
 ',
 ',
 ',
 ',
 '2



'2

DO 0: p0730, DO 1: p0731 AO 0: p0771[0], AO 1: p0771[1] DI 0: r0722.0, …, DI 3: r0722.3
Speed setpoint (main setpoint): p1070[0] = 2050[1]
Jog 1 speed setpoint: p1058, factory setting: 150 rpm
Jog 2 speed setpoint: p1059, factory setting: -150 rpm
Designation in the BOP-2: FB cdS
Installing
4.5 Connecting the interfaces for the inverter control
Converter with the CU230P-2 Control Units
Operating Instructions, 09/2017, FW V4.7 SP9, A5E34257946B AE 115