Siemens SINAMICS G120 - A Parameter Cannot be Changed

A.2.4 A parameter cannot be changed
When cannot you change a parameter?
The inverter indicates why it currently does not permit a parameter to be changed:
Read parameters cannot
be adjusted
The parameter can only be adjusted
during quick commissioning.
A parameter can only be adjusted
when the motor is switched off
2.
V
U


5($'21/<
2.
V
3




3
9
2.
V
3


5811,1*
9
The operating state in which you can change a parameter is provided in the List Manual for
each parameter.
Appendix
A.2 Handling the BOP 2 operator panel
Converter with the CU230P-2 Control Units
Operating Instructions, 09/2017, FW V4.7 SP9, A5E34257946B AE 529