Siemens SINAMICS G120 - Page 353

Changeover for activation via a control command
S>@PRQLWRULQJWLPH
.,QYHUWHURSHUDWLRQ
S>@PRQLWRULQJWLPH
./LQH
RSHUDWLRQ
S>@IHHGEDFNVLJQDO
IURP./LQHRSHUDWLRQ
VLJQDOIRU.
/LQHRSHUDWLRQ
S>@IHHGEDFNVLJQDO
IURP.,QYHUWHURSHUDWLRQ
U VLJQDOIRU.
,QYHUWHURSHUDWLRQ
SE\SDVVFRPPDQG
$FWXDOVSHHGIURP
LQYHUWHU
0RWRUUDWHGVSHHG
,QYHUWHU
2SHUDWL
RQ
,QYHUWHU
2SHUDWLRQ
6ZLWFKRYHU
SKDVH
6ZLWFKRYHU
SKDVH
/LQHVXSSO\
2SHUDWLRQ
5DPSXS
)O\LQJ
UHVWDUW
S
S
S
S
S
S
S
SS
SS
W
W
W
W
W
W
W
W
Figure 6-63 Changeover when activating via a control signal (p1267.0 = 1)
The inverter switches the motor between inverter operation and line operation depending on
the bypass control command p1266.
Advanced commissioning
6.36 Bypass
Converter with the CU230P-2 Control Units
Operating Instructions, 09/2017, FW V4.7 SP9, A5E34257946B AE 353