Function SINAMICS
G120 G120D
9 Setting option for two output reactors using parameter p0235 at the SI‐
NAMICS G120C and SINAMICS G120 with PM240-2 FSD … FSF Power
Module
- ✓ ✓ ✓ ✓ ✓ - - -
10 Efficiency-optimized operation of induction motors
Improved method "Efficiency optimization 2"
✓ ✓ ✓ ✓ ✓ ✓ ✓ ✓ ✓
11 New setting option for the "Technology application" p0500 = 5 during quick
commissioning
✓ ✓ ✓ ✓ ✓ ✓ ✓ ✓ ✓
12 Expansion of the available PROFIdrive telegrams in the SINAMICS G120C
to include telegram 350
- ✓ ✓ ✓ ✓ ✓ - - -
13 An SSI encoder can be parameterized as motor encoder - - - - - ✓ - ✓ -
14 Expansion of the "Basic positioner" function to include the feedback signal
from traversing blocks to the higher-level control system
- - - - - ✓ - ✓ -
15 Expansion to include a feedback signal if a memory card is not inserted in
the inverter:
● Parameter r9401 as BiCo parameter for the optional feedback signal to
the higher-level control system.
● New alarm A01101
✓ ✓ ✓ ✓ ✓ ✓ ✓ ✓ ✓
16 Expansion of the "End stop control" function on the following inverters:
● SINAMICS G120
● SINAMICS G120C
● SINAMICS G120D
✓ ✓ ✓ ✓ ✓ ✓ ✓ ✓ -
17 Expansion of the technology controller to include the following functions:
● Gain K
P
and integral time T
N
can be adapted.
● The system deviation can be used as adaptation signal
- - ✓ - ✓ - - - -
18 Expansion to the torque limiting for SINAMICS G120 inverters with
CU230P‑2 Control Unit
✓ ✓ ✓ ✓ ✓ ✓ ✓ ✓ ✓
Changes in the current manual (Page 5)
Appendix
A.1 New and extended functions
Converter with the CU230P-2 Control Units
516 Operating Instructions, 09/2017, FW V4.7 SP9, A5E34257946B AE
To Next Page
Loading...
