Commissioning
5.7 Alternatively: Creating a project with a device configuration derived from the hardware
112 Getting Started, 12/2018, 6SL3097-5AG30-0BP0
Creating the component topology in Startdrive
After you have checked and, if required, corrected the topology determined in the
configuration, you can transfer this topology to a Startdrive project.
1. Make sure that there are no non-assignable components in the "Device configuration
detection" dialog.
Only when there are no non-assignable components is the "Create" button active.
2. Click the "Create" button.
The topology is created in the device configuration of the selected drive unit.
Figure 5-36 Example: Apply hardware device configuration to Startdrive configuration
To Next Page
Loading...
