Siemens SINAMICS S120 - Inserting and Specifying a Motor Module

Commissioning
5.4 Creating a project offline in Startdrive
78 Getting Started, 12/2018, 6SL3097-5AG30-0BP0
Note
When you use Power Modules, it is usually possible to dispense with an infeed.
General
The procedure for creating and configuring a device in the device configuration of Startdrive
is almost identical for Motor Modules and Power Modules. The drive device configuration
requires at least one of these modules.
These module types differ mainly by their applications:
● Motor Module:
Single-axis and multiple-axis applications
● Power Module:
Single-axis applications
5.4.4.1
Inserting and specifying a Motor Module
Procedure
Proceed as follows to insert and specify a Motor Module in your device configuration:
1. Open "Motor Modules" in the hardware catalog.
A selection can be made from the following Motor Modules:
– Single Motor Modules
– Double Motor Modules
2. Select the required, unspecified Motor Module in the device overview.
Figure 5-12 Motor Module selected