Siemens SINAMICS S120 - Interconnecting BICO Outputs

Fundamentals
4.3 BICO interconnections
54 Getting Started, 12/2018, 6SL3097-5AG30-0BP0
2. Select the parameter that you want to connect.
If connectable bits of the parameter are available, they are displayed in a drop-down list.
Figure 4-3 BICO dialog: Parameter bits opened
3. Select the parameter bit that you want to connect.
4. Confirm with OK.
The connection dialog closes.
Result
The binector or connector input is connected to the selected parameter (bit).
4.3.3
Interconnecting BICO outputs
Use the connection dialog to connect binector or connector outputs.
Connecting a signal
To make a connection, proceed as follows:
1. Click the binector or connector icon of the signal that you want to connect (
or ).
A connection dialog for the selection of the possible parameters opens. The drive object
for which you want to make an interconnection is displayed automatically in the "Drive
object" drop-down list on the right.