Siemens SINAMICS S120 - 8 Commissioning a Drive; Using the Control Panel

Getting Started, 12/2018, 6SL3097-5AG30-0BP0
165
Commissioning a drive
8
8.1
Using the control panel
☐
"Drive axis
> Commissioning > Control panel"
Traverse the drive and test the settings that have already been made with the control panel
(see also the overview in Section "Drive control panel (Page 42)").
WARNING
Non-observance of the safety instructions for the drive control panel
The safety shutdowns from the higher-level controller have no effect with this function. The
"Stop with space bar" function
is not guaranteed in all operating states. Incorrect operation
by untrained personnel – without taking into account the appropriate safety instructions –
can therefore result in death or severe injury.
• Make sure that this function is only used for commissioning, diagnostic and service
purposes.
• Make sure that this function is only used by trained and authorized skilled personnel.
• Make sure that a hardware device is always available for the EMERGENCY OFF circuit.
Note
Drive reacts immediately
Although all enables are removed
before returning the master control, the setpoints and
commands still come from the original parameterized sources after the master control is
returned.
Precondition
● There is an ONLINE connection to the drive unit.