Siemens SINAMICS Series User Manual

Commissioning
8.5 Commissioning with the STARTER commissioning tool
SINAMICS DCM DC Converter
320 Operating Instructions, 12/2018, A5E34763375A
Alternatively, the download to the target system can also be performed as follows:
●
Step 1
Select the menu command
Target system > Download > Project to target system
Selection in the toolbar
Note
Your project data has now been transferred to the drive unit. Presently, this data is only in
the volatile memory (RAM) of the drive unit, however, neither saved in the non
-volatile
memory (ROM) nor on an optionally inserted memory card (see also Chapter
"Memory
card functions
(Page 359)").
To save your project data in the ROM and on the optionally available memory card of
your drive unit so that it is pr
otected against power failure, carry out the following steps.
●
Step 2
Select the menu command
Target system > Target system > Copy RAM to ROM
Selection in the toolbar
Note
The button for copying RAM to ROM
can only be activated if the drive unit has been
marked in the project navigator.
Results of the preceding steps
● You have generated a project for your drive unit using the STARTER offline
● You have saved your project data to your PC hard drive
● You have transferred your project data to the drive unit
● You have saved your project data in your drive unit's FLASH memory so that it is backed
up in the event of a power failure

Siemens SINAMICS Series Specifications

General

Product Line	SINAMICS
Cooling Method	Air-cooled, Liquid-cooled
Voltage Range	200 V to 690 V
Power Range	0.12kW - 250kW
Communication Interfaces	PROFINET, PROFIBUS, Ethernet
Control Modes	Vector control, V/f control
Protection Class	IP20
Type	Variable Frequency Drives (VFD)