Siemens SINUMERIK 802D User Manual

System
8.6 SYSTEM - "Start-up files" softkeys
Cylindrical grinding
148 Programming and Operating Manual, 07/2009, 6FC5398-4CP10-2BA0
Interface parameters
Table 8- 8 Interface parameters
Parameter Description
Device type RTS CTS
The signal RTS (Request to Send) controls the send mode of the data transfer
device.
The CTS signal indicates the readiness to transmit data as the acknowledgment
signal for RTS.
Baud rate ... used to set the interface transmission rate.
300 baud
600 baud
1200 baud
2400 baud
4800 baud
9600 baud
19200 baud
38400 baud
57600 baud
115200 baud
Stop bits Number of stop bits with asynchronous transmission
Input:
1 stop bit (default setting)
2 stop bits
Parity Parity bits are used for error detection. These are added to the coded character to
convert the number of digits set to "1" into an odd or even number.
Input:
No parity (default setting)
Even parity
Odd parity
Data bits Number of data bits with asynchronous transmission
Input:
7 data bits
8 data bits (default)
Overwriting
with
confirmation
Y: When reading in, it is checked whether the file already exists in the NC.
N: The files are overwritten without confirmation warning.
Reading-in and reading-out data of the manufacturer's directory "F".
Reading-in and reading-out data of a USB FlashDrive.
0DQXIDF
WXUHUGULYH
86%
GULYH

Siemens SINUMERIK 802D Specifications

General

Brand	Siemens
Model	SINUMERIK 802D
Category	Control Unit
Language	English