System
8.6 SYSTEM - "Start-up files" softkeys
Cylindrical grinding
Programming and Operating Manual, 07/2009, 6FC5398-4CP10-2BA0
147
Reading-in and reading-out data to a PG/PC via a network. The RCS tool must be installed
on the PG/PC (only for SINUMERIK 802D sl pro).
Note
The RCS tool provides a detailed online help function. Refer to this help menu for further
details e.g. establishing a connection, project management etc.
Reading-in and reading-out data via the RS232 interface.
Note
Using the softkey function "Continue...", you may also inspect the transmission log. The
"Error log" function is available for that.
Use this function to display and change the RS232 interface parameters. Any changes in the
settings come into effect immediately.
Selecting the "Save" softkey will save the selected settings even beyond switching off.
The "Default settings" softkey will reset all settings to their default settings.
Figure 8-43 Parameters of the RS232 interface
5&6
FRQQHFW
56
0RUH
(UURU
ORJ
6HW
WLQJ
To Next Page
Loading...
