Siemens SINUMERIK 802D

Cycles
9.5 Taper grinding - CYCLE405
Cylindrical grinding
166 Programming and Operating Manual, 07/2009, 6FC5398-4CP10-2BA0
Sketch of the geometry parameters
Figure 9-3 Taper grinding - CYCLE405
Programming example
Machining sequence:
Taper grinding at a grinding wheel peripheral speed of 20 m/s. Roughing is machined with
multiple plunge-cuts. A dressing stroke takes place prior to fine-finishing.
N10 T1D1
N20 CYCLE446( 20)
N30 CYCLE405( 0, 0, 200, 100, 120, 0, 10, 0, 1, 0, 2, 2, 0.1, 0.1, 0.03, 0.01, 0.01,
0.005, 0.002, 1, 0, 2, 0, 0, 1, 0.02, 0.01, 2, 1, 0.5, 20, 30, 40, 0, 1, 2, 20)
N40 M30