Cycles
9.12 Radius grinding – CYCLE414
Cylindrical grinding
Programming and Operating Manual, 07/2009, 6FC5398-4CP10-2BA0
193
KS (acoustic emission sensor)
The KS parameter is used to specify whether an acoustic emission sensor is used.
0 = without acoustic emission sensor
1= with acoustic emission sensor
F_KS (feedrate for air grinding)
With an air grinding feedrate, the path between the starting point and the point where the
wheel comes into contact with the workpiece (with the aid of the acoustic emission sensor) is
traversed.
UWERK
Use the UWERK parameter to specify the peripheral speed of the workpiece in m/min.
To Next Page
Loading...
Need help?
General
