Cycles
9.19 Oblique plunge-cutting with Z allowance - CYCLE451
Cylindrical grinding
214 Programming and Operating Manual, 07/2009, 6FC5398-4CP10-2BA0
;B62//
$B)6/
$B6/
$B65
;
=
F_SR, F_SL, F_FSL (feedrate)
Different feedrates can be specified for the individual machining steps. They are
programmed in [mm/min].
F_SR Feedrate for roughing
F_SL Feedrate for finishing
F_FSL Feed rate for fine finishing
TIME (sparking-out time)
After reaching the workpiece finished dimension, the tool dwells at the end position for a
defined time. This time is called 'sparking-out time'. It is programmed in [s].
MZ (measurement control)
The MZ parameter is used to specify whether a measurement control is used.
0 = No measurement control
1 = With measurement control
KS (acoustic emission sensor)
The KS parameter is used to specify whether an acoustic emission sensor is used.
0 = without acoustic emission sensor
1= with acoustic emission sensor
F_KS (feedrate for air grinding)
With an air grinding feedrate, the path between the starting point and the point where the
wheel comes into contact with the workpiece (with the aid of the acoustic emission sensor) is
traversed.
To Next Page
Loading...
