Programming
10.3 Axis movements
Cylindrical grinding
258 Programming and Operating Manual, 07/2009, 6FC5398-4CP10-2BA0
Programming example: End point and radius specification
6WDUWSRLQW
&HQWHUSRLQW"
(QGSRLQW
;
=
5
Figure 10-15 Example for end point and radius specification
N5 G90 Z30 X40 ; Starting point circle for N10
N10 G2 Z50 X40 CR=12.207 ; End point and radius
Note: With a negative leading sign for the value with CR=-..., a circular segment larger than
a semicircle is selected.
Programming example: Definition of end point and aperture angle
r
6WDUWSRLQW
&HQWHUSRLQW"
(QGSRLQW
=
;
Figure 10-16 Example for end point and aperture angle specification
N5 G90 Z30 X40 ; Starting point circle for N10
N10 G2 Z50 X40 AR=105 ; Opening angle and end point
To Next Page
Loading...
Need help?
General
